GEARBOX TOP BOLT FACE CAM TYPE

DESIGNED FOR SPECIAL APPLICATIONS TYPICALLY WHEN THE TOP BOLT FITS IN A HOLE RATHER THAN A SLOT.  THE ORIGINAL TENSIONING LOLLIPOP AND ANCHOR IS NOT REQUIRED AND THIS BOLT GIVES APPROXIMATELY 4.5MM OF ADJUSTMENT WHEN ROTATED VIA THE SMALL LEVER ATTACHED TO THE HEAD.  TYPICALLY IT IS USED ON THE MK3 COMMANDO WHEN FITTING A BELT DRIVE THE SMALL AMOUNT OF ADJUSTMENT BEING ENOUGH TO COMPENSATE FOR THE VARIATIONS FOUND BETWEEN CENTRES.  IT COULD ALSO BE USED ON SPECIALS AND COMPETITION EQUIPMENT WHEN A FIXED CENTRE SET UP IS PREFERRED.  ADDITIONAL ADVANTAGE IS IT EFFECTIVELY ADJUSTS THE GEARBOX FROM BOTH SIDES AND THE BOLT BEING DESIGNED WITH THE RIGHT HAND GROOVE .015" DEEPER HELPS WITH SHAFT ALIGNMENT AS THE MAINSHAFT'S INVARIABLY LEAN FORWARD TOWARDS THE CRANKSHAFT.

MATERIAL IS STAINLESS STEEL AND THE BOLT IS SUPPLIED WITH A STAINLESS NYLOC NUT.

LENGTH UNDER HEAD: 4.430" 
GROOVE WIDTH LEFT HAND: 5/16" (8MM)  RIGHT HAND: .400" (10MM)
HEAD DIAMETER: 1 1/8" (28.5MM)
OVERALL LENGTH: 4 7/8" (124MM) 
DIAMETER: 9/16"
THREAD: 9/16" UNF